rotor造句怎么写

Tubes of suit go back rotor iron chip with suit, cooperate with relevant equipment , realize iron core rivet automation.

Polypropylene fiber spinning project has more than 10 independently-developed patents, and the invention of rotor-spun roving has supply a gap in China.

Think of it as a rotating transformer, with the primary windings residing in a stationary casing (stator) and the secondary conductors attached to an inner shaft (rotor).

This text made FEM calculation and analysis for rotor disk of heavy blower in a plant, and found that the disk can be reused safely again after the arc grooves along outside of blade being repaired.

This means it can hover like a helicopter, but when flying forwards can reduce the speed of the main rotor and let the wings provide part of the lift.

Crucially, though, the demon need pump no energy into the rotor, only information about the position of the rotor, which it USES to switch the field.

The rotor is connected to the main shaft, which spins a generator to create electricity.

In wind power system, a vector control strategy using rotor induct electric potential orientation for doubly fed generator was proposed.

This minuscule rotor wiggled clockwise or anticlockwise as molecules bumped into it from one side or the other.

The modelling inaccuracy and parameter drift in motor control, such as the stator and rotor resistance shift with temperature, act as the disturbance in the control system.

Tesla's invention is, in essence, a rotating transformer. Its primary windings reside in a stationary steel casing (the stator) and and secondary conductors are attached to an inner shaft (the rotor).

The energy in the wind turns two or three propeller-like blades around a rotor.

As they are collected, they are pulled off the rotor by mechanical means to form the yam, and the new yam is wound onto packages. Twist is inserted as the yam is removed from the rotor.

The rotor is then heated and press fit onto a cooled precision-machined one-piece stainless steel shaft and the assembly is then machined and balanced as a unit.

The sealing area on the turbine side of the fore rotor and these on both sides of the after rotor were metalized then the areas were re-machined to the required size.

In practice ,a rotor weighing about 10 tons and rotating at 3,000 r .p . m . may be so well balanced that the motion ,except for sound ,is just perceptible.

An electrical field was then used to apply torque to the rotor, making it harder for the system to spin anticlockwise than clockwise.