simulation results造句怎么写

A good agreement between simulation results and experimental data shows the effectiveness of the simulation method for automobile lateral vibration.

The simulation results show that the system can realistically demonstrate the simulation process of the robot, and besides, it meets the real time requirement of system simulation.

Comparison between distance test method and TIC method for simulation results

In this paper, the numerical simulation results are derived for the turbulent combustor.

The paper simulates the whole process of one light hydrocarbon recovery pant and gives out the main simulation process and simulation results.

It can interact with the simulation model in rotating, translating, scaling and cutaway view or draw postprocessing cloud chart to make researchers easily analyse the simulation results.

The simulation results show that the unbalanced motor results to the vertical vibration and that the peak value of the horizontal acceleration is proportional to the traveling speed.

Verified by simulation results reliable accuracy of calculated results can not be guaranteed for small head change convergence index unless the error of water balance is small too.

The simulation results showed that this method was correct and effective,which had high location accuracy and fast convergence speed.

The simulation results show that the system can depress the overshoot and improve the response and steady state performance.

Finally, simulation results show that the ASAC system has strong robustness to mixed uncertainty and external excitation is suppressed effectively.

CFD simulation results show that the entrance velocity is about 24% higher than the local flow velocity, resulting into large surface shear force, is consistent with the experimental results.

The simulation results show that with this algorithm we can achieve significant time reduction while maintaining the PSNR and bit rate.

In the paper, simulation results also show that the algorithm mentioned above is really satisfactory from the engineering point of view.

The simulation results show that the true optimal FSR solution can be obtained according to the principle proposed in the paper.

The simulation results show that fuzzy control systems which are designed based on the stability have not only good dynamic and steady state feature but also strong rejection ability to disturbances.

The simulation results show that compared with the exist ing star map identification algorithm,the algorithm presented in the paper has the advantages of robust and real time properties and it only needs a sams sized dat abase.

The simulation results are validated by the experiment test. So the validity and practicability of fast finite element simulation model are verified, and the model can be used in the anti-heat fade design and thermal fatigue design of the vehicle brake system.

The simulation results show that the effective measures to improve COP of MHHP include enhancing heat transfer in metal hydride bed, adopting metal hydrides with a sufficiently flat plateau, reducing reactor heat capacities and its mass, and a highly efficient sensible heat exchange.

The experimental simulation results are given lastly.

Computer simulation results show the applicability and superiority of DAR +.

The simulation results are identical to the practice in factories.

These results show that the acoustic simulation results are real, the simulation methods are feasible and the detection methods are reasonable for the simulator.

The simulation results show that the proposed algorithm is an effective one.

The simulation of error bit rate performance for multi -channel and frequency -selective Rayleigh fading is carried out, and the simulation results show that the system is.

With the model the simulation for 5 real car crash tests provided by Japan Automobile Research Institute is conducted and the simulation results basically coincide with the tests.

The results indicate that the simulation results are close to the experimental ones that the modal can be used for simulation of vibration test with attached structural members on it.

However, if the simulation results are not matched by the run-time performance, some work needs to be done.

From the simulation results, it is clear that the power matching system using double-pump can improve efficiency of the CVT hydraulic system greatly.

In the chapter four, I discussed the design of the maglev train braking control system and lay out the simulation results. The results show that the design is feasible.

The simulation results showed that the flow of gas-solid two-phase was non-uniform in axial, radial and tangential directions, and was not symmetric flow as expected, but was up in S-type form.

The simulation results show that guarantee capability for the drop and play-out outage ratio of the proposed scheme outperforms the modified-largest weighted delay first algorithm and exponent proportional fair algorithm, which only take the head-of-line delay into consideration.

The implementation and analysis of simulation results.

The simulation results of life table data of Asian corn borer showed that this model possesses good simulation capability.

Effectiveness and speediness of the proposed method was demonstrated by simulation results.

The simulation results indicate that the new algorithm has approximate results with traditional algorithm, which satisfies the requirements of real time and positioning accuracy.

The simulation results show that the controller ensures the gesture and the energy to the desired goal, farther more the motion control of giant swing backword is realized in the simulation.

Based on the numerical simulation results, this paper analyzed the characteristics of tidal flow fields of Xinghua waterway and Nanri waterway, which provided a basis for waterway planning and design.

The simulation results show that the maximum light output (about 59.1% photon is collected) can be obtained when its incident surface is a coarse surface, the other surfaces are polished surfaces and all its surfaces are coated with high reflecting material.

The simulation results are coincident with the theory analysis ones. The simulation method and results possess an important reference value and guidance to engineering design and capability checkout.

The simulation results show that the algorithm has better real-time performance and robustness than the traditional triangle algorithm.

The simulation results show that the smaller soft faults can be detected and the excellent fault-tolerant performance can be obtained using this gyro configuration and the fault detection algorithm.

The ADAMS software is used to build dynamics simulation models of the dry dock gate system and simulation results show that these models are correctly built.

The simulation results demonstrate the effectiveness of the model.

The simulation results with real aviation remote sensing image show that the improved method effectively keeps the image fractal features and can obtain more accurate fractal dimension.