tolerances造句怎麼寫

Comparison of mean scores of frustration tolerance before and after treatment among clients with different frustration tolerances.

English Name:Welding consumables -- Technical delivery conditions for welding filler materials -- Type of product, dimensions, tolerances and markings.

The tolerances of these machines seem to be very fine because almost any mutation in the underlying genes leads to a misshapen protein and, consequently, to disease.

"The single coil-spring and flexible bellows design provides self-alignment which automatically adjusts to compensate for shaft endplay, run out, primary sealing ring wear, reverse pressure and equipment tolerances. "

The position and orientation errors of the robot end effector are caused by a number of factors such as tolerances in manufacturing and assembly, mechanical transfer errors and so on.

Providing that safe tolerances be set for unavoidable poisonous substances.

Aerospace fitting joint assembly, radial sealing. Internal thread bosses. ISO metric thread profile and tolerances. Dimensions.

Unexpected design issues arise constantly because software has low failure tolerances - much lower than physical systems.

Welding techniques shall be selected to ensure that specified tolerances for straightness and out-of-roundness are not exceeded.

The size accuracy of press tools main ly depends on the cutting edge sizes a nd tolerances of punches and matrixes.

Screeds to higher tolerances than conventional methods.

Numerical examples are given for the broadside array in which the excitation amplitude coefficients have tolerances.

Because of high tolerances inside the crankcase however this can be a difficult and often not very precise task.

Draft allowances can be incorporated into dimensional tolerances or geometric tolerances only upon consultation with the foundry.

If an analyzer with a small level deviation is used, allowing for larger DUT tolerances, the result will be a significant reduction in the production of nonconforming products with immediate benefits.

Matching the resistors as closely as tolerances permitted produced an output impedance of 43 K ohms.