tensile造句怎么写

8、loy high-tensile structural steel

10、the tensile strength ofwire,rope,etc

12、determination of initial longitudinal tensile properties

14、Tensile strength corresponds to the maximum tensile stress that may be sustained by a specimen.

16、Has good abrasion resistance, elasticity, tensile strength and elongation.

18、The tensile strength, bending strength, impact strength, tensile modulus of elasticity and bending modulus of elasticity were determined.

20、test method for tensile properties of carbon fiber strands

22、To measure tensile strength and breaking elongation of and statistic results, With Chinese format menu, tensile curve can be displayed by high-resolution monitor, tensile and elongation data are displayed on the of top the screen.

24、Tensile strength decreased, while the tensile break extension percentage increased first and then decreased, flexural properties was not sensible to the changing humiture.

26、Tensile and microhardness tests show that the quality of joint is better and tensile strength of joint does not decrease greatly compared with that of parent material;

28、And the ultimate tensile strength and elongation of low frequency electromagnetic cast billets are greatly increased.

30、On the contrary, the tensile strength of the system improve with the increase of epoxy content.

32、Connecting pipe, the pipe should have enough deformation allowance, avoid the pipe subjected to tensile force.

34、Finally, the tensile constitutive relation is fitted by the numerical method according to the tensile stress strain curves of PUR foamed plastics, which agrees well with the experimental curves.

36、The experimental results show that, under vibration force field, tensile strength, tensile stress at 100% and elongation at break of TPE can be enhanced, and hardness(shore A) of TPE can be improved.

38、The endochronic constitutive equations under uniaxial and biaxial tensile stress state are given to analyze diffuse instability and localized instability.

40、Direct tension test is the only feasible way to obtain the uniaxial tensile stress-strain curves, and the initial eccentricity is the key issue affecting the uniaxial tensile test results.

42、The result shows that the yielding strength and the tensile strength of HSLA steel can be improved in appropriate relaxation time.

44、Yield strength and ultimate tensile strength, work hardening exponent and normal anisotropy of plastic strain ratio decrease but planner anisotropy of plastic strain ratio increases.

46、Considering the randomness of strength and deformation of concrete material, a mathematic approach of producing random variables series of concrete ultimate tensile strain is proposed.

48、The main factor causing destruction of roadway in tectonic stress field is found to be the high tensile strain, which appears after the coal seam above haulage roadway is mined.

50、The experimental results show that tensile strength is enhanced with the increasing adding of the appropriate organoclay. However, the mechanical property is damaged with the too high clay conte…

52、It is well known that additional stretching of the material in the unsupported wall area may prevent wrinkling, and this can be achieved in practice by increasing the blank-holder force; but the application of excessive tensile stresses leads to failure by tearing.

1、tensile structural plane

3、high tensile steel derrick

5、breaking tensile test of rope

7、brittle materials tensile-strength tester

11、Thermal sprayed coatings--Determination of tensile strength

15、Plastics--Determination of tensile properties by use of small specimens

19、Certain materials can be manufactured with a high tensile strength.

23、The correlation between the compressive strength and axial tensile strength of RCC with placing joint and ultimate tensile strain of placing joint of RCC layers have been obtained.

27、Stress concentration occurs in surrounding rocks, while the maximum tension stress is less than the tensile strength of rock mass, so tensile crack does not take place.

31、The paper discusses the particular requirement in design of the partition wall in tensile buildings.

35、The axial tensile had greater influence on the ultimate strength of the dented riser as the depth was deeper.

39、The tensile strength of the ionomers increases and the ultimate elongation decreases with the increase of sulfonate content.

43、The ultimate tensile strength and elongation of extrusion bar after forging process was much higher than that of the direct extrusion bar.

47、The result reveals that the biaxial oriented PEX pipe can increase the tensile strength by 32.29% at most, while the modulus of elasticity increasing 13.06% and the elongation at break reducing 5.88%.

51、The tensile strength of the reinforced heavy six Angle net is higher than that of the common mesh, and the diameter of the wire is not smaller than the diameter of the side wire.

2、ultra-high tensile steel

6、Geotextiles--Wide width tensile test

13、tensile testing methods for vulcanized rubber

21、Tensile tests revealed that incorporation of CHO improved the stiffness and tensile strength of the terpolymers significantly.

29、The SPPT improves the ultimate tensile strength by 3.5%, and elongation to failure by 25.7% .

37、It increased the Youngs modulus and the maximum tensile stress but it became brittle and decreased the impact strength.

45、This method is ensured to calculate the tensile stress in the recoiling process under the variable coil diameter and speed conditions.

53、The sail-roof structure of Wuhan Stadium is a composite tensile cable-film stress system, its independent longitudinal stress unit is composed of64 umbrella-shape film units, and its integral spatial stress system is composed of corner-tubes, ring beams, horizontal supports of lower draw-bar roof.

9、Metallic materials--Tube--Ring tensile test

25、A improving level and weight model tensile system for band saw machine was devised on existing level and weight tensile, compared to existing mechanism in band saw vibration.

41、The microstructure of Twinning Induced Plasticity (TWIP) steel during tensile deformation was investigated with SEM and TEM.

4、tensile stress relaxation

33、A tensile facture fractal model of grain filled polymer composites on the base of the fractal theory was established, and an equitation of the tensile fracture fractal dimension was proposed.

17、Smoothing algorithms for tensile signals of yarns are described.

49、Experimental data were obtained by means of all kinds of instruments such as a tensile machine, an Izod impact test machine, thermogravimetric analysis, limit oxygen index (LOI) instrument and so on.